The GEO Series electronic time delay switch is just 6.5mm thick and can be used in both 2 and 3 wire modes.
Time delay settings are made by removing the cover plate to access the micro switch toggle. There is no need to remove the switch plate from the wall. The available time settings are 30 seconds to 259 minutes. The Type A and B programs allow a variety of installation and performance options.
Available in white only with optional cover plates in brushed aluminium and brushed brass. This electronic time delay switch comes with a 5 year In House Warranty.
- In applications where a neutral wire is not connected to the product, a minimum load of 35W load must be connected to the product. This is to ensure that a minimum current is available to power the microprocessor in the off state. If a minimum load of 35W cannot be achieved, then a load correction device must be wired. This should be wired in parallel to the load of the electronic time delay switch.
- The installer must ensure that the combined inrush current of the load connected to the device does not exceed the 10A rating of the relay. Failure to do so will reduce the life of the relay contacts and void warranty. Please refer to the PDF datasheet for further information.